Disc brakes are the strongest, most reliable brakes on most bikes — until they stop working well. Most problems have a simple cause. Here is how to find yours.
Safety first: if your brakes feel weak, don’t ride the bike until they’re fixed — except for the slow bedding-in stops in step 3, done away from traffic. Not confident doing a job yourself? Bring it to us.

1. Oil or dirt on the pads or disc
Signs: loud squeal, weak stopping even when you squeeze hard.
Cause: chain lube spray, degreaser, or greasy fingers on the disc.
Fix: clean the disc with isopropyl (rubbing) alcohol or disc-brake cleaner and a clean rag. Oily pads usually can’t be saved — replace them. After cleaning or new pads, bed them in (step 3). If the oil is leaking from the brake itself, bring it to us.
2. Worn-out brake pads
Signs: the lever pulls further than before, braking gets weaker.
Check: look into the caliper. If the pad material is thinner than 1.5mm (not counting the metal backing plate), replace them.
Grinding, metal-on-metal noise? The pads are finished — stop riding now. The disc may need replacing too.
Tip: muddy rainy-season riding can wear out pads in a few weeks.
3. New pads not “bedded in”
Signs: new pads or disc, but weak braking.
Fix: in a quiet, flat car park or road away from traffic, ride to about 20 km/h and brake firmly (don’t lock the wheel) until you’re nearly stopped. Repeat 10–20 times. This lays a thin layer of pad material onto the disc for full power.
4. Spongy lever
Signs: the lever feels soft or squishy, or pulls all the way to the handlebar.
Hydraulic brakes — cause: air in the brake line.
Fix: the brake needs bleeding (removing the air and refilling the fluid). This needs the right tools and the right fluid. Shimano and Magura use mineral oil; Hayes and Hope use DOT fluid. Most SRAM brakes use DOT, but some newer SRAM models use mineral oil. The wrong fluid destroys the seals and the brake fails. Always go by the marking on the lever or caliper — if unsure, bring it to us.
Cable disc brakes: a soft lever usually means the cable needs adjusting or replacing.

5. Rubbing or ticking sound
Signs: rubbing or ticking as the wheel turns.
Cause: the wheel isn’t seated straight, the caliper is slightly out of line with the disc, or the disc is bent.
Fix: first check the wheel is fully and straight in the frame. Then loosen the two caliper bolts, squeeze the brake lever and hold it, and tighten the two bolts a little at a time, in turns, to the figure printed on the part (often 6–8 Nm). No torque wrench? Bring it to us. Test the brake before riding. If the disc wobbles when you spin the wheel, it may need truing or replacing.
6. Brakes fade on long descents
Signs: brakes get weaker on long downhills (Ngong Hills, the Rift Valley escarpment).
Cause: overheating.
Fix: brake in short, firm bursts instead of dragging. If they start fading, stop and let them cool for a few minutes — don’t touch the disc, it burns. Metal (sintered) pads cope with heat better, and bigger discs (up to the size your frame and fork allow) help heavier riders.

Want it done properly?
Brake service, pad replacement and bleeding — call or WhatsApp +254 725 511513 and we’ll book you in.